EPA's Tier 2 Emission Standards for New Motor Vehicles: A Fact Sheet

EPA's Tier 2 Emission Standards for New Motor Vehicles: A Fact Sheet

Order Code RS20247
Updated June 12, 2000
CRS Report for Congress
Received through the CRS Web
EPA's Tier 2 Emission Standards for
New Motor Vehicles: A Fact Sheet
(name redacted)
Environmental Information Analyst
Resources, Science, and Industry Division
The Clean Air Act Amendments of 1990 established “Tier 1” standards to limit
tailpipe emissions from new motor vehicles. The law also required the Environmental
Protection Agency (EPA) to determine if stricter controls would be necessary by model
year (MY) 2004 to assist states in attaining or maintaining the National Ambient Air
Quality Standards. EPA also was required to assess the availability and cost-effectiveness
of technologies necessary to control emissions. In a report submitted to Congress in
August 1998, EPA concluded that tougher standards are necessary and that essential
technologies are available and cost-effective.1 As a result, EPA finalized stricter “Tier 2”
standards on February 10, 2000.2 The new standards will be phased in beginning in
MY2004 and will require all new passenger cars and light trucks up to 8,500 pounds, and
all new heavier passenger vehicles up to 10,000 pounds (including large sport-utility
vehicles), to demonstrate full compliance by MY2009. To improve the efficiency of
emission control technologies, oil refiners also will be required to limit gasoline sulfur
levels to an average of 30 parts per million (ppm) nationwide beginning in 2005, roughly
90% less than the current national average of 340 ppm.
The new Tier 2 standards will require vehicle manufacturers to reduce tailpipe
emissions of carbon monoxide (CO), formaldehyde (HCHO), nitrogen oxides (NO ), non-
x
methane organic gases (NMOG), and particulate matter (PM). However, manufacturers
will have the flexibility to average the NO emissions of their vehicle fleets to demonstrate
x
compliance with the standards instead of certifying each vehicle according to the same
stringency. The standards will require the most reductions in emissions of NMOG and
NO to help control the formation of ground-level ozone pollution. Relative to the Tier
x
1 standards, the fleet average standard for NO will require vehicle manufacturers to
x
reduce overall tailpipe emissions by 88% to 95%. The standards also will require at least
an 80% reduction in PM emissions but will require less stringent reductions in CO
emissions. The standard for HCHO is a new requirement that is intended to reduce
emissions of carcinogenic pollutants. The table on page 2 compares the current Tier 1
standards, which became effective in MY1994, to the new Tier 2 standards that will be
phased in beginning in MY2004.
1 EPA. Office of Air and Radiation. Tier 2 Report to Congress. July 31, 1998. 55 p.
2 EPA. Federal Register. February 10, 2000. p. 6698-6870.
Congressional Research Service ˜ The Library of Congress

CRS-2
Comparison of Tier 1 and Tier 2 Tailpipe Emission Standards for Motor Vehicles
Intermediate Useful Life (grams/mile) a
Full Useful Life (grams/mile) a
Vehicle Type/Weight
NMHC/
NMHC/
CO
NO
PM
HCHO
CO
NO
PM
HCHO
NMOG b
x
NMOG b
x
Tier 1 Standards
LDVs/LDTs (< 3,751 lbs.)
.250
3.4
.40
.08
n/a
.310
4.2
.60
.10
n/a
LDTs (3,751-5,750 lbs.)
.320
4.4
.70
.08
n/a
.400
5.5
.97
.10
n/a
LDTs (> 5,750 lbs.)
.390
5.0
1.10
n/a
n/a
.560
7.3
1.53
.12
n/a
Tier 2 Standards
Final Fleet Average c
n/a
n/a
n/a
n/a
n/a
n/a
n/a
.07
n/a
n/a
Interim Fleet Averages d
n/a
n/a
n/a
n/a
n/a
n/a
n/a
.20/.30
n/a
n/a
Interim Bin 11 e
n/a
n/a
n/a
n/a
n/a
.280
7.3
.90
.12
.032
Interim Bin 10 f, g
.125/.160
3.4/4.4
.40
n/a .015/.018
.156/.230
4.2/6.4
.60
.08 .018/.027
Interim Bin 9 f, g
.075/.140
3.4
.20
n/a
.015
.090/.180
4.2
.30
.06
.018
Bin 8 g
.100/.125
3.4
.14
n/a
.015
.125/.156
4.2
.20
.02
.018
Bin 7
.075
3.4
.11
n/a
.015
.090
4.2
.15
.02
.018
Bin 6
.075
3.4
.08
n/a
.015
.090
4.2
.10
.01
.018
Bin 5
.075
3.4
.05
n/a
.015
.090
4.2
.07
.01
.018
Bin 4
n/a
n/a
n/a
n/a
n/a
.070
2.1
.04
.01
.011
Bin 3
n/a
n/a
n/a
n/a
n/a
.055
2.1
.03
.01
.011
Bin 2
n/a
n/a
n/a
n/a
n/a
.010
2.1
.02
.01
.004
Bin 1
n/a
n/a
n/a
n/a
n/a
.000
0.0
.00
.00
.000
a The intermediate useful life standards set a benchmark for the amount of pollutants that a vehicle is expected to emit after being driven
for 50,000 miles. The Tier 1 full useful life standards reflect the amount of pollutants that a vehicle is expected to emit after 100,000
miles of vehicle use. The Tier 2 standards increase the full useful life benchmark to 120,000 miles. If a manufacturer voluntarily chooses
to certify a vehicle to a higher useful life of 150,000 miles, compliance with the Tier 2 intermediate standards is optional.
b Tier 1 vehicles are subject to the testing procedure for NMHC, but Tier 2 vehicles will be subject to the testing procedure for NMOG.
Both pollutants are closely related hydrocarbon compounds that can combine with NO in the presence of sunlight to form ground-level
x
ozone pollution. EPA selected the NMOG testing procedure under Tier 2 because it more accurately measures hydrocarbon levels.
c Each manufacturer will have the flexibility to select any set, or “bin”, of emission standards when certifying different models of vehicles,
as long as it meets the fleet average requirement for NO emissions.
x
d During the phase-in period, the interim fleet average for LDVs and LLDTs will be .30 grams/mile and will expire at the end of
MY2006. The interim fleet average will be .20 grams/mile for HLDTs and MDPVs and will expire at the end of MY2008.
e Bin 11 will only apply to MDPVs and will expire at the end of MY2008 when phase-in is complete.
f Bins 9 and 10 will expire at the end of MY2006 for LDVs and LLDTs and at the end of MY2008 for HLDTs and MDPVs.
g The higher values will apply only to HLDTs during the phase-in period and will expire at the end of MY2008.
LDV = light duty vehicle (<6,001 lbs.)
LLDT = (light) light duty truck (<6,001 lbs.)
HLDT = (heavy) light duty truck (6,001-8,500 lbs.)
MDPV = medium duty passenger vehicle (8,501-10,000 lbs.)
NMHC = non-methane hydrocarbons
NMOG = non-methane organic gases
CO = carbon monoxide
NO = nitrogen oxides
x
PM = particulate matter
HCHO = formaldehyde
Prepared by the Congressional Research Service based on data from the Environmental Protection Agency.

EveryCRSReport.com
The Congressional Research Service (CRS) is a federal legislative branch agency, housed inside the
Library of Congress, charged with providing the United States Congress non-partisan advice on
issues that may come before Congress.
EveryCRSReport.com republishes CRS reports that are available to al Congressional staff. The
reports are not classified, and Members of Congress routinely make individual reports available to
the public.
Prior to our republication, we redacted names, phone numbers and email addresses of analysts
who produced the reports. We also added this page to the report. We have not intentional y made
any other changes to any report published on EveryCRSReport.com.
CRS reports, as a work of the United States government, are not subject to copyright protection in
the United States. Any CRS report may be reproduced and distributed in its entirety without
permission from CRS. However, as a CRS report may include copyrighted images or material from a
third party, you may need to obtain permission of the copyright holder if you wish to copy or
otherwise use copyrighted material.
Information in a CRS report should not be relied upon for purposes other than public
understanding of information that has been provided by CRS to members of Congress in
connection with CRS' institutional role.
EveryCRSReport.com is not a government website and is not affiliated with CRS. We do not claim
copyright on any CRS report we have republished.